Husky Baby Carrier - Manual (Page 9)

4 Verify that the vehicle belt is
not twisted, then buckle (Fig. D).
5 While kneeling on the restraint
to push it firmly into the vehicle
backrest, remove all slack from the
vehicle belt.
• First remove slack from the lap
portion of the vehicle belt, then
the shoulder portion (Fig. E).
6 Verify that the vehicle belt is
tight and the child restraint is
secure.
• Refer to Figure F for correct routing
Removal
Reverse installation procedure.
Installation
15
Lap-Shoulder Belt Installation
Short Route
Figure A illustrates a typical short
route lap-shoulder belt installation.
WARNING:
• Always use the Versa-Tether ®
when installing restraint using
the short vehicle belt route (see
pages 18–19).
• Do not install this restraint using
a non-locking ELR vehicle belt,
unless a locking clip is used.
Refer to the vehicle owner's
manual for instructions on
correct use of vehicle belts with
child restraints.
1 Place the child restraint in a
forward facing position on the
vehicle seat.
2 Pull the vehicle belt out and pass it
through the first belt slot, from the
rear of the restraint to the front
(Fig B).
3 Route the vehicle belt under
the cover then through the
second belt slot, from the front of
the restraint to the rear (Fig. C).
Installation
14
D
E
F
B
A
C
P2219_R03.qxd 8/18/2004 11:04 AM Page 16