HONDA HS520AS - Manual (Page 14)

BEFORE OPERATION
12
Check the General Condition of the Snowthrower
• Look around and underneath the snowthrower for signs of oil or
gasoline leaks.
• Check the auger housing and the discharge chute for accumulation
of packed snow or ice. Clean the auger housing and discharge
chute before starting the snowthrower.
• Look for signs of damage.
• Check each control for proper operation.
• Check auger paddles for wear. Replace if necessary (page 28).
• Check the scraper blade for wear. Replace if necessary (page 30).
• Check that all nuts, bolts, and screws are tightened.
Check the Engine
• Check the oil level (page 23).
• Check the fuel level (page 22). Starting with a full tank will help to
eliminate or reduce operating interruptions for refueling.
CHECK YOUR WORK AREA
For your safety and the safety of others, always inspect the area
before operating the snowthrower.
Objects
Anything which can be picked up by the auger and thrown is a
potential hazard to you and others. Look for hazards and remove them
from the work area.
People and Pets
People and animals near the work area can move into your
snowthrower’s path or into a position where they could be struck by
thrown objects. Clear the area of people, especially children and pets.
Their safety is your responsibility.
Work Area
Check the condition of the snow. Adjust your snowthrower ground
speed and snowblowing swath accordingly.
Check the scraper blade for proper adjustment. Check the scraper
blade for the correct auger ground clearance (page 29).