Heath Zenith 6270 Series User Manual

Page 2

Advertising
background image

-2-

595-5506-12

12345

678

Jumpers

Chime Volume

Sawtooth Hanger

Figure 4

5. Mount push button. Use either screws or double

sided tape to mount push button.

Screw Mounting: To mount with screws, remove
back of case by pushing in tab on bottom with a small
screwdriver (see Figure 1). Note: Remove material in
screw holes (if needed) before mounting with screws.
Attach back of case to door jamb or wall (see Figure
3). Snap front of push button on.

Tape Mounting: When attaching push button using
double sided tape, make sure the surface of the door
jamb or wall is clean.

6. Mount chime. Determine mounting location.

There are different ways to mount the chime depending
upon the model of chime purchased. Determine which
model you purchased below. Mount the chime according
to the instructions for your chime.

Chime with Attached Decorative Cover:
1. Drill 1/4" diameter pilot hole for wall anchor (provided) and insert anchor.
2. Screw #8 screw (provided) into anchor. Leave 1/16" gap between screw head

and wall.

3. Place hanger over screw to mount chime (see Figure 4).

Figure 3

Sawtooth Hanger

Screw

Advertising
This manual is related to the following products: