Harbor Freight Tools 90374 User Manual
Page 13
SKU 90374
PAGE 13
7.
Lightly apply the oscillating Sand Paper Pad (17D) to the workpiece surface, and
begin sanding the workpiece by moving the tool forward and backward
with
(parallel to) the grain
of the workpiece.
8.
Once the sanding job is completed, release pressure on the Switch (3D) to turn off
the Sander. (See Figure F.)
9.
IMPORTANT: If, during the sanding process it becomes necessary to replace
worn sand paper with new sand paper, make sure to turn off the Sander and
disonnect the Battery (1A). Re-install new sand paper and
then
re-attach the
Battery. (See Figure F.)
BATTERY (1A)
SANDER
HANDLE
SAND PAPER
PAD
(17D)
SWITCH
(3D)
SANDER HANDLE
BATTERY (1A)
FIGURE F
To Operate The Jigsaw:
1.
Make sure the Battery (1A) is disconnected from the Jigsaw prior to attaching the
Saw Blade (16E) to the tool.
2.
To attach the Saw Blade (16E) to the Jigsaw, use the Hex Key (24E) to loosen the
two Hex Socket Screws (14E). (See Figure G, next page.)
3.
Insert the shank of the Saw Blade (16E) upward into the Blade Holder (15E) with
its saw teeth pointing to the front of the tool. Then, re-tighten the two Hex Socket
Screws (14E) to secure the Saw Blade in place. (See Figure G.)
4.
If desired, the angle of a cut may be adjusted. To do so, loosen the Hex Socket
Screw (14E) located on the underside of the Sander. Tilt the Base Plate (19) to
the desired angle. Then, re-tighten the Hex Socket Screw. (See Figure G.)