Heath Zenith SL-6143 - Manual (Page 3)

-3- 595-5649-05
12345678
12345678
Inside
Push
Button
Push Button Battery Replacement
Install an alkaline type A23 12 Volt bat-
tery. See diagram inside push button for
correct battery orientation.
* Code Settings 1-7 Must
Match Both Push Button
and Chime
Remove screw to
open access door
Back of
Chime
• Ding (one note tune)
Push Button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune) (Available on selected Heath ® /Ze-
nith chimes)
Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. You
may purchase any Heath
® /Zenith wireless push button for a second
entrance. We recommend the back door use the Ding tune and the
front door use the Ding-Dong tune (or Westminster tune, available
on selected Heath
® /Zenith chimes). Models that include two push but-
tons will come factory set for front and back doors. Decals on the rear
of the push button will indicate its setting.
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Tune Setting
(Not used on
all models)
Tune Setting