Heath Zenith 2LBL9 - Manual (Page 6)

6 598-1326-01
CautION: to avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and the fixture
operate at high temperatures.
• Keep fixture at least 2" (5 cm) from combustible materials.
Do not aim at objects closer than 3 feet. (1 m).
• Use only T3, 100W (max.) tungsten halogen 120 VAC
lamps.
Bulb Installation
NOtE: Bulbs are included, but you will need to install them.
NOtE: When replacing bulb, turn power off and let the fixture
cool.
1. Open glass cover. Remove the old bulb by pushing the bulb
towards the right until the left side of the bulb is clear of the
left socket.
IMPORTANT: Do not handle new bulb with bare skin. Oil from
skin can greatly reduce bulb life. Use clean gloves or a cloth
to install new bulb.
2. To insert the new bulb, push the bulb into the right socket so
the bulb fits completely into the left socket.
3. Check that the bulb is seated properly.
4. Close the glass cover.