Troubleshooting guide, Regulatory information – Heath Zenith 2LBL9 User Manual

Page 8

Advertising
background image

8

598-1326-01

trOuBLESHOOtING GuIDE

POSSIBLE CauSE

1. Circuit breaker or fuse is turned off.

2. Switch on device is turned off.
3. Interrupted by another device.

4. Does not respond immediately after

installation.

5. Signals from transmitter are being

blocked, or transmitter is out of range.

6. Weak battery in the transmitter.

7. Dip switches on transmitter and receiver

units do not match.

8. Device is defective.

1. Same as 5, 6, and 7 above.

1. Short term power line failure.

2. Another transmitter on the same

frequency.

SYMPtOM

Device does not come on.

Device does not turn off.

Device comes on randomly.

SOLutION

1. Verify circuit breaker or fuse is turned

on.

2. Verify switched device is turned on.
3. Change codes on transmitter and

receiver units.

4. Wait for 90 second initialization period

(remote motion sensor).

5. Check for metal objects that could

block the signal, or reposition the
transmitter.

6. Check battery charge and replace if

necessary.

7. Verify code settings on transmitter and

receiver units are set the same.

8. Test using different device.

1. Same as 5, 6, and 7 above.

1. Next transmission from transmitter

will reset receiver to correct state.

2. Change codes on transmitter and

receiver units.

rEGuLatOrY INFOrMatION

This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
The term “IC:” before the radio certification number only signifies that Industry Canada technical specifications were met.
The user is cautioned that changes or modifications not expressly approved by the party responsible for regulatory compliance could
void the user’s authority to operate the equipment.

1 YEar LIMItED WarraNtY:

Should this product fail to perform satisfactorily due to a defect or poor workmanship within one year of date of purchase, return it
to the place of purchase and it will be replaced, free of charge. Incidental or consequential damages are excluded from this war-
ranty. Light bulbs are not covered.

Manufactured for Grainger International, Inc.
Lake Forest, IL 60045

Advertising
This manual is related to the following products: