Document Outline

• Introduction
  • Warnings and Notice Conventions
  • Contacting ETC
  • Overview
• Prepare for Installation
  • Unpack and Inspect
  • Main Circuit Breaker Protection
  • Using 90° Copper Wire
  • Maximum Current Draw
    • Short Circuit Current Rating (SCCR)
  • Where to Install the Enclosure
    • Clearance Requirements
    • Dimensions and Weights
    • Installation Environment Requirements
    • Wire Routing and Specification
    • Control Specifications
      • Control Wire Specification
        • Data Types and Topologies
• Install Enclosures
  • Mounting Individual DRd Enclosures
    • Mounting Individual Enclosures on a Wall
  • Mounting a DRd Enclosure on a Pedestal
  • Mounting Auxiliary and DRd Enclosures Together
• Rough-in Conduit and Wiring
  • Prepare the DRd Enclosure
    • Remove the DRd Power Supply/Dimming Engine Access Panel
    • Modify Phase Bus for 120V AC Split Phase Operation
  • Rough-in Conduit to the DRd Enclosure
    • Procedure
• Terminate Wiring
  • Connect Line Power Wiring
    • Connect Line Feed in an Individual DRd Installation
      • 100, 120, 127 V AC, 3Ø DRd Enclosures
      • 230V AC Neutral Disconnect DRd Enclosures
      • 240, 277V AC DRd Enclosures
  • Connect Load Wires
  • Fluorescent Load Wiring
    • 3-wire Fluorescent
    • 2-wire Fluorescent
  • Connect Control Wiring
    • Overview
    • DRd Right I/O Data Terminations
      • Auxiliary Power
      • LinkConnect and EchoConnect Control Wiring
      • UL 924 Listed Panic Input
      • DMX Control Wiring
        • DMX Input Wire Termination using the Screw Terminals Connector
        • DMX Input Wire Termination using the Insulation Displacement Connector (IDC)
      • AX12X Cross-bussed Interconnection
      • Terminate the Unison Options (URTO and UBPO)
      • Terminate DMX
    • DRd Left I/O Data Termination
      • Connect to Serial RS-232
      • Connect to Ethernet RJ-45
      • Connect to Contact Inputs and Contact Outputs
        • Terminate Contact Inputs
        • Terminate Contact Outputs
• Install Option Kits
  • Installation of Option Kits
    • DALI Option
      • Install the DALI Option kit
      • Connect DALI Option Wiring
    • 0-10V Control Option Kit
      • Connect 0-10V Control Option Wiring
    • RideThru Option Kit
      • Install the RideThru Option Kit
      • Connect RideThru Option Wiring
    • BatteryPack Option Kit
      • Install the BatteryPack Option Kit
• Final Installation and Power Up
  • Checking the Installation before Installing Modules
    • Sealing Air Leaks
    • Final Installation
    • Control Bypass (Test Mode)
    • Reengage Module Retention Bar
• Modules Specification
• CE 230V Emergency Modules
  • About Emergency Modules
  • Wire Termination
    • Non Neutral Disconnect
    • Neutral Disconnect