Document Outline

• MVME712-12, MVME712-13, MVME712A, MVME712AM, and M...
  • (MVME712A/D3)
  • Notice
  • Restricted Rights Legend
    • Motorola, Inc. Computer Group 2900 South Diablo Wa...
  • Preface
  • Safety Summary Safety Depends On You
    • GENERAL INFORMATION
  • Introduction
  • Features of the MVME712 Family Modules
  • Features of the LCP2 Adapter Board
  • Specifications
    • Table 1-1. MVME712 Family Specifications
    • Cooling Requirements
    • FCC Compliance
      • 1. Shielded cables on all external I/O ports.
        • 2. Cable shields connected to earth ground via met...
        • 3. Conductive chassis rails connected to earth gro...
        • 4. Front panel screws properly tightened.
  • General Description
    • HARDWARE PREPARATION AND INSTALLATION
    • Introduction
    • Unpacking Instructions
    • MVME712x Module Preparation
      • Figure 2-1. MVME712-12 Header Locations
      • Figure 2-2. MVME712-13 Header Locations
      • Figure 2-3. MVME712A Header Locations
      • Figure 2-4. MVME712AM Header Locations
      • DSR Line Pull Up Select Headers (J8, J9, J13, J14)...
• J8
  • Serial Port 2/Modem Port 2 Select (J16, J17)
    • Serial Port Configuration
• J16
  • Modem Port Configuration
• J16
  • SCSI Termination
  • MVME712B Module Preparation
    • Figure 2-5. MVME712B Connector Locations
  • LCP2 Adapter Board Preparation
    • Figure 2-6. LCP2 Adapter Connector Locations
  • Installation Instructions
    • 1. Turn all equipment power OFF and disconnect the...
      • 2. Remove the chassis cover as instructed in the e...
      • 3. Remove the filler panel(s) from the appropriate...
      • 4. Continue with the specific procedure for instal...
    • Installing for Use with Internal SCSI Devices
      • 1. Verify that SCSI terminators are installed on t...
        • 2. Install the LCP2 adapter module to the backplan...
        • 3. Connect a user-supplied cable with compatible p...
        • 4. Verify that terminators are installed on the la...
        • 5. MVME712-12 and MVME712-13: Attach the cable sup...
        • 6. Insert the transition module into the selected ...
        • 7. After making sure you will not pinch cables wit...
        • 8. Connect the power cable to the AC power source ...
        • 9. If SCSI does not work properly, you may have to...
        • Figure 2-7. Internal SCSI and Serial Port Connecti...
    • Installing the MVME712-13 and MVME712AM as a Modem...
      • 1. Install the LCP2 adapter module to the backplan...
        • 2. Verify that serial port 2 is configured as a mo...
        • 3. MVME712-13: Attach the cable supplied with the ...
        • 4. Connect a user-supplied cable from connector J2...
        • 5. Insert the MVME712-13 or MVME712AM module into ...
        • 6. After making sure you will not pinch cables wit...
        • 7. Connect a user-supplied Telco modular cable to ...
        • 8. Connect the power cable to the AC power source ...
        • Figure 2-8. Internal SCSI and Modem Connections
    • MVME712B Installation
      • 1. Verify that SCSI terminators are installed on t...
        • 2. Install the LCP2 adapter module to the backplan...
        • 3. MVME712-12 and MVME712-13: Attach the cable sup...
        • 4. Connect the SCSI INTERFACE cable on the MVME712...
        • 5. Connect the ETHERNET cable on the MVME712B to c...
        • 6. Insert the MVME712B module into the selected sl...
        • 7. Connect a user-supplied cable with compatible p...
        • 8. Verify that terminators are installed on the la...
        • 9. After making sure you will not pinch cables wit...
        • 10. Connect the power cable to the AC power source...
        • 11. If SCSI does not work properly, you may have t...
        • Figure 2-9. MVME712B External SCSI Connections
        • SUPPORT INFORMATION
  • Introduction
  • Interconnect Signals
    • Table 3-1. LCP2 and MVME712 Connectors
    • Table 3-2. MVME712 Jumpers
    • Connector P2 Interconnect Signals (LCP2 Adapter)
    • Connectors J1, J3-J5 Interconnect Signals (MVME712...
      • Table 3-3. Connectors J1, J3-J5 Interconnect Signa...
    • Connector J2 Interconnect Signals (LCP2 Adapter)
      • Table 3-4. Connector J2 Interconnect Signals (LCP2...
    • Connector J2 Interconnect Signals (MVME712-13, MVM...
      • Table 3-5. Connector J2 Interconnect Signals (MVME...
    • Connector J3 Interconnect Signals (LCP2 Adapter) C...
      • Table 3-6. Connector J3 Interconnect Signals (LCP2...
    • Connector SCSI INTERFACE Interconnect Signals (MVM...
      • Table 3-7. SCSI INTERFACE Interconnect Signals (MV...
    • Connector ETHERNET Interconnect Signals (MVME712B)...
      • Table 3-8. ETHERNET Interconnect Signals (MVME712B...
    • Connector J6 Interconnect Signals (MVME712-13, MVM...
      • Table 3-9. Connector J6 Interconnect Signals (MVME...
    • Connector J7 Interconnect Signals (MVME712-13, MVM...
      • Table 3-10. Connector J7 Interconnect Signals (MVM...
    • Connector J10 Interconnect Signals (MVME712x)
      • Table 3-11. Connector J10 Interconnect Signals (MV...
    • Connector P2 and J11 Interconnect Signals (MVME712...
      • Table 3-12. Connector P2, J11 Interconnect Signals...
    • Connector J12 Interconnect Signals (MVME712-13, MV...
      • Table 3-13. Connector J12 Interconnect Signals (MV...
    • Connector J15 Interconnect Signals (MVME712x)
      • Table 3-14. Connector J15 Interconnect Signals (MV...
  • Parts Lists and Locations
    • Table 3-15. MVME712x Module Parts List (Continued)...
    • Figure 3-1. MVME712-12 Parts Location Drawing (Pri...
    • Figure 3-2. MVME712-13 Parts Location Drawing (Pri...
    • Figure 3-3. MVME712A Parts Location Drawing (Prima...
    • Figure 3-4. MVME712AM Parts Location Drawing (Prim...
    • Figure 3-5. MVME712x Parts Location Drawing (Secon...
    • Table 3-16. MVME712B Module Parts List
    • Figure 3-6. MVME712B Parts Location Drawing
    • Table 3-17. LCP2 Adapter Module Parts List
    • Figure 3-7. LCP2 Adapter Module Parts Location Dra...
  • Schematic Drawings
    • MODEM
  • General Description
  • Modem Features
    • Table A-1. Modem Features
  • Technical Specifications
    • Table A-2. Technical Specifications (Continued)
    • Table A-3. Autodialer Characteristics
    • A
    • B
    • C
    • D
    • E
    • F
    • G
    • H
    • I
    • J
    • L
    • M
    • O
    • P
    • R
    • S
    • T
    • U