Mvme712b installation, Verify that scsi terminators are installed on t, Install the lcp2 adapter module to the backplan – Motorola MVME712B User Manual
Page 31: Mvme712-12 and mvme712-13: attach the cable sup, Connect the scsi interface cable on the mvme712, Connect the ethernet cable on the mvme712b to c, Insert the mvme712b module into the selected sl, Connect a user-supplied cable with compatible p, Verify that terminators are installed on the la, After making sure you will not pinch cables wit
Hardware Preparation and Installation
2-16
MVME712-12/-13/A/AM/B Transition Modules and LCP2 Adapter Board UserÕs Manual
2
MVME712B Installation
The MVME712B is designed to be used in conjunction with one of the
MVME712x modules (MVME712A, MVME712AM, MVME712-12, or
MVME712-13). The MVME712x can be connected through the MVME712B to
external SCSI devices as shown in
.
Because the MVME1xx VMEmodule is at one end of the cable, SCSI
terminators are required on the LCP2 adapter. The LCP2 adapter module is
shipped with SCSI terminators installed.
To install the MVME712B in the system, proceed as follows:
1.
Verify that SCSI terminators are installed on the LCP2 adapter module.
2.
Install the LCP2 adapter module to the backplane directly in line with the
P2 connector on the MVME1xx VMEmodule. Be sure to orient pin 1 of the
adapter with pin 1 of the backplane connector.
3.
MVME712-12 and MVME712-13
: Attach the cable supplied with the
MVME712x module from LCP2 adapter connector J2 to connector P2 on
the MVME712x module. Be sure to orient cable pin 1 with connector pin 1.
See
MVME712A and MVME712AM
: Attach the cable supplied with the
MVME712x module from LCP2 adapter connector J2 to connector J11 on
the MVME712x module. Be sure to orient cable pin 1 with connector pin 1.
See
4.
Connect the SCSI INTERFACE cable on the MVME712B to connector J3 on
the LCP2 adapter.
5.
Connect the ETHERNET cable on the MVME712B to connector J10 on the
MVME712x.
6.
Insert the MVME712B module into the selected slot and tighten the
attaching screws.
7.
Connect a user-supplied cable with compatible pinouts from the SCSI
interface on the front panel of the MVME712B to the external SCSI devices.
8.
Verify that terminators are installed on the last SCSI device on the cable. If
they are not present, install terminators.
9.
After making sure you will not pinch cables with the cover, reinstall the
cover you previously removed.
10. Connect the power cable to the AC power source and turn the unit on.
11. If SCSI does not work properly, you may have to repair a defective cable
and/or replace a blown fuse.