Motorola MVME712B User Manual
Page 51
Support Information
3-18
MVME712-12/-13/A/AM/B Transition Modules and LCP2 Adapter Board UserÕs Manual
3
A16
32
RTS3
REQUEST TO SEND (serial port 3) - RTS is supplied
by the terminal to the modem when it is required to
transmit a message. With RTS off, the modem carrier
remains off. When RTS is turned on, the modem
immediately turns on the carrier.
C17
33
DCD3
DATA CARRIER DETECT (serial port 3) - sent by the
modem to the terminal to indicate that a valid carrier
is being received.
A17
34
DTR3
DATA TERMINAL READY (serial port 3) - a signal
from the terminal to the modem indicating that the
terminal is ready to send or receive data.
C18
35
TXD1
TRANSMIT DATA (serial port 1) - data to be
transmitted is furnished on this line to the modem
from the terminal.
A18
36
GND
GROUND
C19
37
RXD1
RECEIVE DATA (serial port 1) - data that is
demodulated from the receive line is presented to the
terminal by the modem.
A19
38
GND
GROUND
C20
39
RTS1
REQUEST TO SEND (serial port 1) - RTS is supplied
by the terminal to the modem when it is required to
transmit a message. With RTS off, the modem carrier
remains off. When RTS is turned on, the modem
immediately turns on the carrier.
A20,C21
40,41
GND
GROUND
A21
42
CTS1
CLEAR TO SEND (serial port 1) - CTS is a function
supplied to the terminal by the modem, and
indicates that it is permissible to begin transmission
of a message. When using a modem, CTS follows the
off-to-on transition of RTS after a time delay.
C22
43
GND
GROUND
A22
44
TXD4
TRANSMIT DATA (serial port 4) - data to be
transmitted is furnished on this line to the modem
from the terminal.
C23
45
GND
GROUND
Table 3-12. Connector P2, J11 Interconnect Signals (MVME712
x) (Continued)
Pin Number
Signal
Mnemonic
Signal Name and Description
P2
J11