Motorola MVME712B User Manual
Page 38
Interconnect Signals
MVME712A/D3
3-5
3
20
PRACK*
DATA ACKNOWLEDGE (Printer) - a low level
input pulse indicating that the next character
may be sent.
21
PRPE
PAPER EMPTY (Printer) - out of paper.
22
PRBSY
BUSY (Printer) - an input signal indicating that
the printer cannot receive data.
23
INPRIME*
INPUT PRIME (Printer) - an output signal that
clears the printer buffer and initializes the logic.
24
PRSEL
SELECTED (Printer) - an input signal indicating
that the printer is selected.
25
GND
GROUND
26
PRFAULT*
FAULT (Printer) - an input signal that indicates
a printer fault condition.
27
GND
GROUND
28
TXD3
TRANSMIT DATA (serial port 3) - data to be
transmitted is furnished on this line to the
modem from the terminal.
29
GND
GROUND
30
RXD3
RECEIVE DATA (serial port 3) - data that is
demodulated from the receive line is presented
to the terminal by the modem.
31
CTS3
CLEAR TO SEND (serial port 3) - CTS is a
function supplied to the terminal by the modem,
and indicates that it is permissible to begin
transmission of a message. When using a
modem, CTS follows the off-to-on transition of
RTS after a time delay.
32
RTS3
REQUEST TO SEND (serial port 3) - RTS is
supplied by the terminal to the modem when it
is required to transmit a message. With RTS off,
the modem carrier remains off. When RTS is
turned on, the modem immediately turns on the
carrier.
33
DCD3
DATA CARRIER DETECT (serial port 3) - sent
by the modem to the terminal to indicate that a
valid carrier is being received.
Table 3-4. Connector J2 Interconnect Signals (LCP2 Adapter) (Continued)
Pin
Number
Signal
Mnemonic
Signal Name and Description