Document Outline

• Introduction
  • Description
  • DLCM Standard Features
  • Options
  • Accessories
• Safety Considerations
  • General Safety
    • Explosive Atmosphere Safety
    • Electrical Safety
    • Mechanical Safety
    • Hydraulic Safety
• Equipment Inspection
• Storage Instructions
  • Storage Length
    • Short Term (0 - 12 months)
    • Long Term (12 months or more)
• Installation
  • Location
  • Installation Notes
  • Electrical Wiring
    • Getting Started
    • Finding your way around the Field Wiring Board
  • High Voltage Connections
    • Supply Power
    • PULSAR Motor
    • Alarm Relay
  • Low Voltage Input Connections
    • Analog Inputs
    • Alarm Input
    • Level Input (Remote Start/Stop)
  • Low Voltage Output Connections
    • Current Output
    • Alarm Dry Contact Output
    • Run Status or Stroke Counter
  • Tachometer Input
  • Motor Thermostat
  • Serial Communications Input
  • Fuse Replacement
• Start Up Instructions
  • Overview
    • User Interface Familiarization.
      • Display:
      • Keypad:
      • Manual Adjustment Knob:
    • Check Wiring and Close Access cover
    • Confirm Correct Incoming Power
    • Confirm Display and Keypad functionality
    • Performing a Factory Re-initialization
    • Test Pump Motor
    • Set Time and Date
    • Flow Calibration (1-point).
    • Analog Input Calibration.
      • One – Signal Analog Input Calibration
      • Two – Signal Analog Input Calibration
  • Wrapping up.
• General Operation
  • General Operation Instructions
    • Pump Flow Calibration
    • Analog Input Signal Calibration
      • Analog Input #1 Calibration
      • Analog Input #2 Calibration
    • Reverse Acting Analog Input Signal Calibration
    • Analog Output Signal Calibration
  • Menu
    • Alarm, and Error messages
    • Diagnostics
    • Set Time and Date
    • Analog Signal Failure Set Up
    • MODBUS Signal Failure Setup
    • Analog Output Set Up
    • Motor Speed Display
    • End Point Set Up
      • End Point Example
    • Leak Detection Failure Set Up
    • Level / Remote / Start – Stop Set Up
    • Digital Output Set Up
    • Motor Thermostat Set Up
    • Over Temperature Set Up
    • Power Failure Set Up
    • Alarm Relay
    • Analog Mode
      • Setting the One – Signal mode
      • Setting the 2 – Signal mode
    • MODBUS Mode
      • {STROKE & SPEED / 1 – SIGNAL} Setup
      • {STROKE & SPEED / 2 – SIGNALS} Setup
    • Security
    • Number Format
    • Contrast Adjust
    • Serial Communications
    • Serial Diagnostics
      • Loopback Test Procedure
    • Language
    • Factory Default Settings
  • Units
  • Varying the Flow Rate - Manually
  • Mode
  • Batch
    • One Time Only
    • Repeating
    • Overlapped
      • Inactivating The Batches
• Diagrams: Installation / Component
• Specifications
  • Overview
• Factory Default Values
• Trouble Shooting Guide
  • System Diagnostics
    • Encoder Diagnostics
    • Tachometer Troubleshooting
    • Tachometer Upgrade Adjustment Instructions
• Conversion (Manual to DLCM)
• General Repairs
  • Emergency Manual Pulsar Operation
  • DLCM Replacement
• PulsaNet Specification
  • Introduction
  • Operational Overview
  • MODBUS Messaging
  • PulsaNet DDE Server Messaging
  • Coils
  • Input Bits (1x references)
  • Input Registers
  • Holding Registers
• MODBUS Mode
  • Introduction
  • General Discussion
• Spare Parts
• Diagnostic Form