Pulsafeeder Pulsar DLCM User Manual
Installation operation maintenance instruction
Advertising
INSTALLATION
OPERATION
MAINTENANCE
INSTRUCTION
BULLETIN No. IOM-PS-DLCM-1101-Rev E
Manufacturer’s of Quality Pumps,
Controls and Systems
Engineered Pump Operations
2883 Brighton-Henrietta Townline Road
Rochester, New York 14623
Telephone: (585) 292-8000 Fax: (585) 424-5619
E-mail: [email protected]
Advertising
Table of contents
Document Outline
- Introduction
- Safety Considerations
- Equipment Inspection
- Storage Instructions
- Installation
- Start Up Instructions
- General Operation
- General Operation Instructions
- Menu
- Alarm, and Error messages
- Diagnostics
- Set Time and Date
- Analog Signal Failure Set Up
- MODBUS Signal Failure Setup
- Analog Output Set Up
- Motor Speed Display
- End Point Set Up
- Leak Detection Failure Set Up
- Level / Remote / Start – Stop Set Up
- Digital Output Set Up
- Motor Thermostat Set Up
- Over Temperature Set Up
- Power Failure Set Up
- Alarm Relay
- Analog Mode
- MODBUS Mode
- Security
- Number Format
- Contrast Adjust
- Serial Communications
- Serial Diagnostics
- Language
- Factory Default Settings
- Units
- Varying the Flow Rate - Manually
- Mode
- Batch
- Diagrams: Installation / Component
- Specifications
- Factory Default Values
- Trouble Shooting Guide
- Conversion (Manual to DLCM)
- General Repairs
- PulsaNet Specification
- MODBUS Mode
- Spare Parts
- Diagnostic Form