Homelite HG6000 - Manual (Page 13)

Page 13
ASSEMBLY
UNPACKING
This product requires assembly.

Remove one end of the box and carefully slide out the
generator and any accessories.
NOTE: The generator is heavy. If you must lift the unit
out of the box, get another person to help you and lift
with your legs, not your back.
 Inspect the unit carefully to make sure no damage oc-
curred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-260-8280 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to heed
this warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not attempt to operate the generator until assembly
is complete. Failure to comply could result in possible
serious personal injury.
INSTALLING THE WHEELS
See Figure 3.
Wheels are provided to assist in moving the generator to the
desired location and should be installed on the side opposite
the recoil starter.
NOTE: Install the wheels before installing the handle. Do not
put fuel or oil in the generator before installing the wheels.

Locate the following items:
2 wheel axles 2 wheels
2 small cotter pins 2 large cotter pins
 Raise the end of the generator opposite the recoil starter
high enough to gain access to the frame bottom; securely
position props underneath to support.
 Locate the U-bracket on one side of the frame bottom.
Slide a wheel axle through the bracket so that an end
extends from both sides of the bracket.
 On the end that extends inside the generator frame, insert
a small cotter pin through the hole in the axle to secure.
Bend the ends of the cotter pin to prevent the pin from
slipping out.
 Place a wheel over the other end of the axle.
 Insert a large cotter pin through the hole in the axle. Bend
the ends of the pin to secure.
 Repeat the process on the other side.
INSTALLING THE FRAME SUPPORTS
See Figure 4.
Install the two frame supports provided on the bottom side
of the generator frame opposite the wheels.

Locate the following items:
2 frame supports 6 bolts
 Raise the end of the generator where the recoil starter is
located high enough to gain access to the frame bottom;
securely position props underneath to support.
 Align the holes on the frame support with the holes on
the generator frame.
 Insert a bolt through the hole in the generator frame so it
extends down through the frame support.
 Tighten bolt to secure.
 Repeat with the two remaining screws.
 Repeat on other side to install second frame support.
FRAME SUPPORT
WITH FOOT
Fig. 3
Fig. 4
WHEEL
AXLE
SMALL
COTTER
PIN
WHEEL
U-BRACKET
LARGE
COTTER
PIN
HOLE
BOLT