HP XW3400 - Manual (Page 99)

Speaker
1 . Prepare the workstation for disassembly ( Preparation for disassembly on page 59 ).
2 . Remove the access panel and rotate the workstation so the system board is parallel to the table to
make it easier to work on ( Access panel on page 61 ).
3 . Remove the hard drive cables from the plastic shroud at the front of the chassis and from the hard
drives.
4 . Remove the shroud from the chassis ( Fan shroud on page 84 ).
5 . Disconnect the speaker wire from the system board connector.
6 . Remove the two screws (1) that secure the speaker to the chassis.
7 . Remove the speaker by lifting it up (2) and out of the retaining clips.
To install the speaker, reverse the removal procedures making sure that the speaker wire is at the upper
left of the speaker when viewed from inside the chassis.
ENWW Speaker 89