HONDA MK SG-2 - Manual (Page 21)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 21
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
III. Roughening or Preparing a Surface:
A) Configure the Cutting Drum for Grooving (See Section 3)
B) Adjust the Cutting Drum Depth until the Cutting Discs are contacting the surface (increase the depth of
the Cutting Drum as necessary to increase the “roughness of the surface”
C) Move the SG-2 in a smooth forward motion
D) Should the Cutting Discs loose contact with the surface, repeat Step B and continue forward motion
E) Repeat Steps A through D until the desired number of grooves are cut (See Figure 3)
3. Cutting Drum Configurations:
The following Cutting Drum configurations allow the user to set up the SG-2 Cutting Drum for the most
commonly used configurations.
Set depth to
contact the surface
Maintain set
cutting depth
Direction of movement
Figure 3
One-inch grooves
General Purpose 1 General Purpose 2
Line (stripe) removal