HP 2600 - Manual (Page 113)

Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Telnet
CLI: Modifying the Interface Access
Interface Access Commands Used in This Section
show console below
[no] telnet-server below
[no] web-management page 7-6
console page 7-6
Listing the Current Console/Serial Link Configuration. This com­
mand lists the current interface access parameter settings.
Syntax: show console
This example shows the switch’s default console/serial configuration.
Interface Access
Enable/Disable
Console Control
Options
Event Log Event
Types To List
Figure 7-2. Listing of Show Console Command
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax: [no] telnet-server
To disable inbound Telnet access:
HPswitch(config)# no telnet-server
To re-enable inbound Telnet access:
HPswitch(config)# telnet-server
7-5