Ip addressing in a stacking environment, To configure ip addressing, Ip addressing in a stacking environment -5 – HP 2600 User Manual
Page 127
Configuring IP Addressing
IP Configuration
■
The IP addressing used in the switch should be compatible with your
network. That is, the IP address must be unique and the subnet mask must
be appropriate for your IP network.
■
If you change the IP address through either Telnet access or the web
browser interface, the connection to the switch will be lost. You can
reconnect by either restarting Telnet with the new IP address or entering
the new address as the URL in your web browser.
IP Addressing in a Stacking Environment
If you are installing the switch into an HP ProCurve stack management
environment, entering an IP address may not be required. See the chapter on
stack management in the Advanced Traffic Management Guide.
Menu: Configuring IP Address, Gateway, and Time-To-
Live (TTL)
Do one of the following:
■
To manually enter an IP address, subnet mask, set the
IP Config parameter
to
Manual and then manually enter the IP address and subnet mask values
you want for the switch.
■
To use DHCP or Bootp, use the menu interface to ensure that the
IP Config
parameter is set to
DHCP/Bootp, then refer to “DHCP/Bootp Operation” on
page 8-12.
To Configure IP Addressing.
1. From the Main Menu, Select.
2. Switch Configuration ...
5. IP Configuration
N o t e
If multiple VLANs are configured, a screen showing all VLANs appears instead
of the following screen.
8-5