HP 2600 - Manual (Page 179)

Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
For example, to configure a broadcast limit of 45% on ports 1 - 10 in a Series
2800 Switch:
Configures a broadcast
limit of 45% on ports 5 - 7 in
the running configuration.
Displays the broadcast-
limit in the running-config
file.
Figure 10-1. Configuring and Displaying a Per-Port Broadcast Limit on Switch 2800 Series Device
Configuring HP Auto-MDIX
Copper ports on the switch can automatically detect the type of cable config­
uration (MDI or MDI-X) on a connected device and adjust to operate appro­
priately.
This means you can use a “straight-through” twisted-pair cable or a “cross-
over” twisted-pair cable for any of the connections—the port makes the
necessary adjustments to accommodate either one for correct operation. The
following port types on your switch support the IEEE 802.3ab standard, which
includes the “Auto MDI/MDI-X” feature:
HP ProCurve Series HP ProCurve Series HP ProCurve Switch HP ProCurve 6108
2600 Switch
2800 Switch Series 4100gl Switch
10/100-TX ports 10/100/1000-T ports 10/100-TX gl 10/100/1000-T ports
module ports
10/100/1000-T ports 100/1000-T gl
module ports
10/100/1000-T gl
module ports
10-13