HP 2600 - Manual (Page 249)

Port Trunking
Port Status and Configuration
LACP Notes and Restrictions
802.1X (Port-Based Access Control) Configured on a Port. To main­
tain security, LACP is not allowed on ports configured for 802.1X authenticator
operation. If you configure port security on a port on which LACP (active or
passive) is configured, the switch removes the LACP configuration, displays
a notice that LACP is disabled on the port(s), and enables 802.1X on that port.
HPswitch(config)# aaa port-access authenticator e b1
LACP has been disabled on 802.1X port(s).
The switch will not allow you to configure LACP on a port on which port
access (802.1X) is enabled. For example:
HPswitch(config)# int b1 lacp passive
Error configuring port < port-number >: LACP and 802.1X cannot be run
together.
To restore LACP to the port, you must first remove the port’s 802.1X configu­
ration and then re-enable LACP active or passive on the port.
Port Security Configured on a Port. To maintain security, LACP is not
allowed on ports configured for port security. If you configure port security
on a port on which LACP (active or passive) is configured, the switch removes
the LACP configuration, displays a notice that LACP is disabled on the port(s),
and enables port security on that port. For example:
HPswitch(config)# port-security a17 learn-mode static address-limit 2
LACP has been disabled on secured port(s).
The switch will not allow you to configure LACP on a port on which port
security is enabled. For example:
HPswitch(config)# int a17 lacp passive
Error configuring port A17: LACP and port security cannot be run together.
To restore LACP to the port, you must remove port security and re-enable
LACP active or passive.
Changing Trunking Methods. To convert a trunk from static to dynamic,
you must first eliminate the static trunk.
12-23