Hearth and Home Technologies Bravo - Manual (Page 29)

Hearth & Home Technologies, Inc. • Bravo, Aztec • InD • 703-900 Rev. N • 8/06 29
CAUTION
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Shock hazard.
• Replace damaged wire with type 105
O C
rated wire.
• Wire must have high temperature insulation.
WARNING
Figure 10.1 Intellifi re Pilot Ignition (IPI) Wiring Diagram
NEUTRAL GROUND
REMOTE
CONTROL HOT
VALVE
BROWN
BROWN
ORANGE
GREEN
BLACK
BLACK (SENSOR)
BLACK
GROUNDTO
FIREPLACE
CHASSIS
PILOT ASSEMB LY
AND VALVE ASSEMBLY
MUST BE GROUNDED
(COMMON GROUND
WITH FIREPLACE
CHASSIS)
PLUG-IN
3V TRANSFORMER
IGNITION
MODULE
(3V)
I
S
2045-024
2012-206
BLACK (IGNITO R )
WA L L SWITCH
TRANSFORMER
3 V
LOW VOLTA G E
SEE NOTE 1
LOW VOLTA G E
SEE NOTE 1
IGNITOR
MODULE
3V
FAN OUTLET RECEPTACLE
(NO FAN OPTION)
SPARK TO
PILOT IGNITOR
NOTE 1: Ignition module, valve, pilot and wall switch
operate on 3 volts. 120 VAC is required at junction box
unless equipped with battery back-up.
BLACK (IGNITOR)
3V
PILOT ASSEMBLY
AND VALVE ASSEMBLY
3V
WALL SWITCH
LOW VOLTAGE
SEE NOTE 1
LOW VOLTAGE
SEE NOTE 1