Hearth and Home Technologies SL-550TRSI-AUE - Manual (Page 31)

31 Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06
2.1 SAFETY & LIGHTING INFORMATION
Follow SAFETY INFORMATION and LIGHTING IN-
STRUCTIONS to light the appliance.
By design, the flame pattern will not be identical from
unit to unit. Additionally, flame pattern may vary depend-
ing on installation type and weather conditions.
After the unit has warmed up (i.e. approximately 15 min-
utes) flame height should be slightly (about 2" (51mm)
below the top of the mesh trim assembly. If the flame
height is higher than this, adjustments must be made to
prevent overheating the gasket and glass. Please con-
tact your dealer or a qualified service person to replace
the injector or adjust the valve.
NOTE: THE TIPS OF THE FLAMES SHOULD NEVER
HIT THE TOP OF THE FIREBOX.
These gas models have remote control valve which al-
low you to increase or decrease the height of the main
burner flames. Push the button to increase the flame
height and the
button to decrease the flame height.
LIGHTING
INSTRUCTIONS
TO TURN OFF
GAS TO APPLIANCE
1. Push the "OFF" button on remote.
2. Remove power from receiver.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WA R N I N G : If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance is equipped with
an electronic ignition device
which automatically lights the
burner. Do not try to light the
burner by hand.
B. BEFORE LIGHTING, smell all
around the appliance area for
gas. Be sure to smell next to the
floor because some gas is
heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
DO NOT CONNECT 220/240
VAC TO THE CONTROL VALVE.
Improper installation, adjustment,
alteration, service or maintenance
can cause injury or property dam-
age. Refer to the owner's informa-
tion manual provided with this ap-
pliance.
This appliance needs fresh air for
safe operation and must be in-
stalled so there are provisions for
adequate combustion and ventila-
tion air.
If not installed, operated, and main-
tained in accordance with the
manufacturer's instructions, this
product could expose you to sub-
stances in fuel or fuel combustion.
Keep burner and control compart-
ment clean. See installation and
operating instructions accompany-
ing appliance.
CAUTION:
Hot while in operation. Do not
touch. Keep children, clothing, fur-
niture, gasoline and other liquids
having flammable vapors away.
Do not operate the appliance with
panel(s) removed, cracked or bro-
ken. Replacement of the panel(s)
should be done by a licensed or
qualified service person.
• Do not touch any electric switch;
do not use any phone in your build-
ing.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
C. Do not use this appliance if any
part has been under water. Imme-
diately call a qualified service tech-
nician to inspect the appliance and
to replace any part of the control
system and any gas control which
has been under water.
NOT FOR USE
WITH SOLID FUEL
For use with natural, propane and
butane gases.
WARNING:
GAS
VALVE
1. This gas fireplace is equipped with an
ignition device which automatically
lights the burner. Do not try to light the
burner by hand.
2. Wait five (5) minutes to clear out any
gas. Then smell for gas, including near
the floor. If you smell gas, STOP! Fol-
low "B" in the Safety Information located
on the left side of this label. If you don't
smell gas, go to next step.
3. To light the burner, simultaneously
press the star and up arrow but-
tons on the remote control until a short
acoustic signal confirms the start se-
quence has begun.
4. If the gas fireplace will not operate,
check the batteries then follow the
instructions “To Turn Off Gas to Ap-
pliance” and call your service techni-
cian or gas supplier.