Hitachi P50V701 - Manual (Page 15)

15
Rear Panel Connections
(POD) module).
Digital Cable Signal
INSERT INSERT
NOTE: 1. A digital cable subscription is required.
2. Do not insert a PCMCIA card into the
CableCARD slot.
If the CableCARD is properly installed or removed, the
TV will display the following respective screens.
After the CableCARD is installed, wait until the second
screen below appears.
Please take note of all information on the screen (you
will provide this information to your cable operator).
Call your cable operator and give them the information
from the card to start your cable service.
OR
CableCARD is not installed
CableCARD is installed
In order to start cable service
for this device, please contact
your cable provider
CableCARD(tm): 123-456-789-1
Host: 123-456-789-1
Data: 123-456-789-1
Unit Address: 123-456-789-1
Press EXIT to return
Acquiring Data.
Please wait.
ቭ CableCARD Slot
This slot is for the CableCARD that will be provided
by your local cable operator to gain access to
chosen cable channels. The CableCARD will allow
you to tune digital and high definition encrypted cable
programming.
Please call your local cable operator if
this service is available before requesting a
CableCARD (also known as Point of Deployment
1. Connect a coaxial cable to cable terminal of
the Rear Panel Jacks.
2. Insert the CableCARD into the slot (Top of card
should be facing towards you as shown
below).
F
ir
s
t
tim
e
u
s
e