Setting up the wine chiller, Assembling the door, Unpacking – Honeywell 88065 User Manual

Page 6: Location of the chiller, Wood racks in the chiller

Advertising
background image

6

ASSEMBLING THE DOOR

1)

Screw

2)

Door handle

To save shipping space and avoid damage of the

wine chiller during transportation, the door handle

of this unit is shipped unassembled. Before setting

up the chiller, please assemble the door handle as

follows:

Locate the door handle and 2 screws attached

inside the cabinet.

With the 2 screws attached, fasten the door handle

onto the frame of the door panel as illustrated.

You may be required to pull away a section of the

rubber seal to find the screw holes. Simply pull off

the seal and place back into the grooves.

UNPACKING

Remove all packing materials and accessories. Examine the chiller for any damage such as

dents or broken door. Do not install if chiller is damaged.
Allow the chiller to stand upright for approximately 2 hours before connecting the power

source.
If discarding an old chiller, please see “Important Safety Instructions” on page 3.

LOCATION OF THE CHILLER

Find a suitable area for your wine chiller. Do not place the chiller outside, or any other

place where the chiller will be exposed to water or other harsh weather conditions. The

chiller must not be placed in environments where the ambient temperature drops

below 18°C (65°F ) degrees or goes above 29°C (85°F) degrees. The ideal ambient

temperature is 22.2°C (72°F).
CAUTION: DO NOT PLACE THE WINE CHILLER IN A COLD LOCATION. IT

WILL INCREASE THE RISK OF FREEZING.

SETTING UP THE WINE CHILLER

WOOD RACKS IN THE CHILLER

The wine chiller comes with wood racks. They are already in place in the chiller upon

delivery. For your convenience, they easily slide in and out. If you remove the racks for

any reason, make sure the wood attached edge always faces out when placing them back

in the chiller.

3)

Rubber Seal

4)

Door Panel

1.

4.

3.

2.

Advertising