Huffy M611412 - Manual (Page 10)

10
ID# M611412 04/05
Attach pole assembly to tank assembly as shown. Secure pole assembly to tank
and wheel bracket by turning the pole assembly clockwise as shown. Tighten
pole completely and further rotate pole until struts are aligned correctly as shown
in FIG B.
5.
FIG B
The pole should be turned
approximately 7 complete
rotations to tighten properly.
When properly tightened, the
wheel bracket will be tight
against the base. An assistant
is recommended to hold the
base in place during this step.
TWO PEOPLE REQUIRED
FOR THIS PROCEDURE.
FAILURE TO FOLLOW THIS
WARNING COULD RESULT
IN SERIOUS INJURY AND/OR
PROPERTY DAMAGE.
WARNING!
IMPORTANT!