Huffy M611412 - Manual (Page 8)

8
ID# M611412 04/05
2.
IMPORTANT!
ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
THE IDENTIFICATION STICKER IS
LOCATED 3-3/4" FROM THE END
OF THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 2-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/4" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!
5
4
4
5
6
Align poles using alignment marks. First, pound top
and middle poles together by bouncing them on a scrap
piece of wood on the ground as shown in FIG A. until
they no longer move toward pole identification stickers.
THEN add bottom pole section and pound together in
the same way FIG B.
FIG. A.
FIG. B.
TROUGH
GORGE
RINNE
CANAL
IMPORTANT!
HOLE
DIMPLE
5"
ID
STICKER
1-1/2"
TROUGH
Wood Scrap
(NOT SUPPLIED)