Furuno CSH-24F - Manual (Page 23)

18
Positioning guide pins
Guide pins of the connector are used to identify the mating receptacle. Position them shown
below.
Table 4-2 Guide pins and connector CN-E1
Clamping the cable (side at power supply unit)
Clamp the cable as shown in below.
Figure 4-11
Fabricating cable 10S1259 (connected terminal board TB-E1)
Figure 4-12 Fabricating cable 10S1259
Fabricating cable DPYCY- 4
(connected to terminal board TB-E1)
M4 (YEL) x 2
Anticorrosive
sheath
Armor Vinyl
sheath
330
35
30
Conductor
S =
4.0 mm
ø = 2.55 mm
2
Vinyl
sheath
Armor
Cable DPYCY- 4
Note: DPYCY- 4 is Japan standard cable.
Use equivalent cable.
Figure 4-13 Fabricating cable DPYCY-4