Freedom9 USB - Manual (Page 7)

4
5. Insert the hard drive and connector into the enclosure and push inward until the connector is
flush with the casing (Figure 4).
Figure 4: Inserting the Hard Drive
6. Screw both screws back into the enclosure (Figure 1).
7. Connect one end of the included USB cable to the freeStor Mini 210, and connect the other
end to a USB port on your computer (Figure 5).
Figure 5: Connecting the USB Cable
Note: If your hard drive does not power on after connecting the freeStor Mini 210
to your computer, it may mean that your hard drive requires more power than a
single USB port can deliver. Plug the USB power cable into the power jack on the
unit, and connect the other end to a USB port on your computer.
2.2 Installing a Hard Drive for freeStor Mini 310
1. Remove the freeStor Mini 310 hard drive enclosure from the package.
2. Unscrew the two screws on each side of the enclosure (Figure 6).
Warning: After unscrewing the two screws, both ends will become loose and
may fall out if the unit is held vertically.
Figure 6: Screws to Remove