FUJITSU fi-4750C - Manual (Page 82)

7-13
17. Adjust ADF Erasing Edges
<Screen 57>
1 Press “Next” or “Previous” and let the
scanner display Screen 57.
2 At Screen 57, press or to select “Yes”
and press . Then the scanner displays
Screen 57-1.
<Screen 57-1>
3 At Screen 57-1, select “Yes” to return the
settings to the factory default or select “No”
to make new settings (as shown below).
Then press
. The scanner displays
Screen 57-2.
<Screen 57-2>
4 At Screen 57-2, press or to change the
top setting. The value changes in 1 mm
units. Then press
to activate the
setting. The scanner displays Screen 57-3.
<Screen 57-3>
5 At Screen 57-3, press or to change the
bottom setting. With (+:Up), the area is set
upward from the bottom edge of the image.
With (–:Down), the area is set downward from
the bottom edge of the image. The value
changes in 1 mm units. Then press
to
activate the setting. The scanner displays
Screen 57-4.
<Screen 57-4>
6 At Screen 57-4, press or to change the
left setting. The value changes in 1 mm
units. Then press
to activate the
setting. The scanner displays Screen 57-5.
<Screen 57-5>
7 At Screen 57-5, press or to change the
top setting. The value changes in 1 mm
units. Then press
to activate the
setting. The scanner displays the next setup
item.