FUJITSU C150-E187-01EN User Manual
Page 69
63
•
The value for custom paper is higher than the maximum scan size. Width needs to equal 279
mm or less and length needs to equal 420 mm or less.
•
The value for custom paper is higher than the maximum scan size. Width needs to equal 11
inch or less and length needs to equal 16.53 inch or less.
•
The value for custom paper is higher than the maximum scan size. Width needs to equal xxx
pixel or less and length needs to equal xxx pixel or less.
Cause:
A value exceeding the limit applicable to the scan area of the scanner
was specified.
User response:
To specify a custom paper size, specify the value that is smaller than
the value applicable to the device.
•
The resolution must be less or equal to xxx dpi when scanning in Gray Scale.
Cause:
A value exceeding the limit of resolution for gray-scale scan was
specified.
User response:
Specify a resolution value that is below the indicated xxx dpi.
•
Cannot specify Gray Scale with Custom resolution.
Cause:
Custom resolution was designated when multi-tone (gray scale) was
designated.
User response:
Designate a resolution value other than Custom.
•
Cannot specify Individual Setting with Gray Scale.
Cause:
Gray scale was specified in the settings for the front side or back side
was set as the object to be set.
User response:
Specify Gray Scale only when making the settings for both sides.
•
Dither pattern file not found.
Cause:
File download has been specified, but a file has not been selected.
User response:
Use the [File…] button to specify a file.
•
Gamma pattern file not found.
Cause:
File download has been specified, but a file has not been selected.
User response:
Use the [File…] button to specify a file.
•
Selected file could not delete.
Cause:
If the selected setting file is write-protected, it cannot be deleted.
User response:
Use Explorer to delete the file later.