FUJITSU C150-E187-01EN - Manual (Page 73)

67
•
Illegal format or data in download file.
Cause: The format of the specified download file is illegal or the data is
incorrect.
User response: User response: Use an editor to check file format and data.
•
ASPI manager not found.
Cause: The ASPI manager may not have been installed, or may have been
deleted.
User response: Reinstall the products, including the ASPI manager attached to the
SCSI board. Then reboot the PC.
•
Scanner DLL file not found.
Cause: An image scanner was selected, but the DLL file of the selected image
scanner has not been installed in the directory in which this driver is
installed.
User response: Perform the setup again.
•
A parameter error has occurred (internally)
•
The calling procedure is invalid (internally).
•
The area is specified incorrectly (internally).
•
The calculation result exceeded the value that can be expressed (internally).
•
User definition is not registered (internally).
Cause: This is a program error that occurs during command exchange
between the driver and the image scanner.
User response: Try again by rebooting the machine. If the error persists, contact the
retail store where the product was purchased or the nearest service
center.
•
A general fault of the MSG_XXXXX response (internally).
Cause: This is a program error that usually occurs during internal message
transfer. This message involves the sub-messages described later.
User response: Contact the retail store where the product was purchased or the
nearest service center.
•
A general fault of the DAT_XXXXX response (internally).
Cause: This is a program error that usually occurs during internal data
transfer. This message involves the sub-messages described later.