Fortinet FortiGate 100 User Manual
Installation and configuration guide, Fortigate 100
Advertising
Table of contents
Document Outline
- Table of Contents
- Introduction
- Getting started
- NAT/Route mode installation
- Preparing to configure NAT/Route mode
- Using the setup wizard
- Using the command line interface
- Connecting the FortiGate unit to your networks
- Configuring your networks
- Completing the configuration
- Configuration example: Multiple connections to the Internet
- Transparent mode installation
- Preparing to configure Transparent mode
- Using the setup wizard
- Using the command line interface
- Connecting the FortiGate unit to your networks
- Completing the configuration
- Transparent mode configuration examples
- System status
- Changing the FortiGate host name
- Changing the FortiGate firmware
- Manual virus definition updates
- Manual attack definition updates
- Displaying the FortiGate serial number
- Displaying the FortiGate up time
- Backing up system settings
- Restoring system settings
- Restoring system settings to factory defaults
- Changing to Transparent mode
- Changing to NAT/Route mode
- Restarting the FortiGate unit
- Shutting down the FortiGate unit
- System status
- Session list
- Virus and attack definitions updates and registration
- Updating antivirus and attack definitions
- Registering FortiGate units
- Updating registration information
- Recovering a lost Fortinet support password
- Viewing the list of registered FortiGate units
- Registering a new FortiGate unit
- Adding or changing a FortiCare Support Contract number
- Changing your Fortinet support password
- Changing your contact information or security question
- Downloading virus and attack definitions updates
- Registering a FortiGate unit after an RMA
- Network configuration
- Configuring interfaces
- Viewing the interface list
- Bringing up an interface
- Changing an interface static IP address
- Adding a secondary IP address to an interface
- Adding a ping server to an interface
- Controlling management access to an interface
- Configuring traffic logging for connections to an interface
- Configuring the external interface with a static IP address
- Configuring the external interface for DHCP
- Configuring the external interface for PPPoE
- Changing the external interface MTU size to improve network performance
- Configuring the management interface (Transparent mode)
- Adding DNS server IP addresses
- Configuring routing
- Providing DHCP services to your internal network
- Configuring interfaces
- RIP configuration
- System configuration
- Firewall configuration
- Users and authentication
- IPSec VPN
- PPTP and L2TP VPN
- Configuring PPTP
- Configuring L2TP
- Network Intrusion Detection System (NIDS)
- Antivirus protection
- Web filtering
- Email filter
- Logging and reporting
- Glossary
- Index