FORD F-150 C3493 - Manual (Page 16)

16
C3493pr-0922
Hint: Before assembling the pretend engine, you may want to
install the battery. Please refer to page 19, steps 2 and 3.
• Fit the pretend engine into the front end of the vehicle.
• Insert two 1" bolts into the pretend engine.
• Tighten the screws.
• Fit a peg on the hood into a slot in the front end of the vehicle.
• Flex the hood slightly and then insert the other hood peg into the
other slot in the front end of the vehicle.
• Lower the hood. Push down near the front of the hood to
“snap” into place.
Hood Peg
Slot
27
28
VEHICLE CARE
• Check all screws, hex nuts and their protective coverings
regularly and tighten as required. Check plastic parts on
a regular basis for cracks or broken pieces.
• During snowy or rainy weather, the vehicle should be stored
inside or under a protective cover. Remember to charge the
battery at least once per month while your vehicle is not in
regular use.
• Avoid operating the vehicle in wet or snowy conditions, and do
not spray the vehicle with a hose. Do not wash the vehicle with
soap and water. Water or moisture in the motors or electrical
switches can cause them to corrode, and could cause switch
or motor failure.
• Avoid operating the vehicle on sand, loose dirt or gravel.
Sand, loose dirt or gravel in the motors or electrical switches
can cause them to jam, and could cause switch or motor failure.
• The vehicle can be wiped down with a soft, dry cloth. For a shiny
finish, you can wipe plastic parts with a non-wax furniture
polish applied to a soft-cloth. Do not use automotive wax.
• To ensure that your vehicle stays in good operating order,
we recommend that you periodically have your vehicle checked
by a Power Wheels ® authorized service center. For the location
of the authorized service center nearest you, please visit us
on-line at www.powerwheels.com or call 1-800-348-0751.
ASSEMBLY
Pretend
Engine