Fantom Vacuum FANTOM PT302H - Manual (Page 9)

Remove the plug from the power source before
assembly, changing accessories or cutters and
making adjustments. This safety action will help
prevent accidental starting of the tool which could
result in serious injury.
ON / OFF SWITCH
This Rotary Tool is equipped with a sliding ON / OFF switch
(1) located on the top of the tool (see Fig. 1).
1. To turn the tool ON, slide the switch up.
2. To turn the tool OFF, slide the switch down.
INSTALLING CUTTING BITS
Cutting bit and router bit cutting surfaces are
extremely sharp. Handle with caution.
To insert a cutting bit, use the collet wrench which is in the
wrench holder attached to the power cord.
1. Depress the shaft locking button (1) and rotate the
collet lock nut (2) clockwise with the other hand until
the locking button drops into place, preventing the
shaft from turning (see Fig. 2).
2. While continuing to hold the shaft locking button IN,
use the collet wrench (3) to turn the collet nut counter
clockwise. Loosen the collet nut 2 or three turns.
3. Remove bit if one is already installed in the tool.
INSTALLING CUTTING BITS – Cont’d
4. Insert new cutting bit (4) into the collet.
Insert the bit all the way into the collet and then
pull it back between
1 /
16
” and 1 /
8
”. This creates an
air space between the motor shaft and the bit to
help prevent overheating the bit.
Before tightening the collet on the bit, make sure
the flutes (spiral portion) of the bit are completely
visible outside the collet. Clamping the collet on
the bit flutes will result in broken bits and
possible injury.
5. When bit is properly placed in the collet, depress the
shaft locking button and turn the collet nut clockwise
by hand as far as possible.
6. Securely tighten collet nut using the wrench.
ASSEMBLY & OPERATION
WARNING !
Fig. 1
WARNING !
Fig. 2
WARNING !
9