Finisar FWDM-1629-XX - Manual (Page 7)

FWDM-1629-XX DWDM SFP Preliminary Product Specification – February 2005
F i n i s a r

Finisar Corporation PRELIMINARY and Confidential Page 7
Rev C, February 2005
VI. Wavelength Stabilization
The laser transmitter will not be turned on until its temperature is adjusted to ensure
operation within the specified channel (X +/- 0.4nm). This temperature stabilization time is
dependent on the ambient temperature conditions, but will typically occur within 90
seconds of powering the device. The device will transmit within the specified wavelength
tolerance (X +/- 0.1nm) within 5 seconds of transmitter operation.
VII. General Specifications
VIII. Environmental Specifications
Parameter
Symbol Min Typ Max Units Notes/Conditions
Operating Temp T
op
-5 70 °C Case temperature measured on top-side of
device
Storage Temp T
sto
-10 85 °C Ambient temperature
Eye Safety CDRH and IEC-825 Class 1 Laser
Product. See Note 1
Note 1: Complies with FDA performance standards for laser products except for deviations pursuant to
Laser Notice No. 50, dated July 26, 2001.
Parameter
Symbol Min 1.25 Max Units Notes/Conditions
Data Rate BR 1.06 1.25 Gb/sec Fibre Channel, IEEE 802.3
compatible
Total System Budget 30 32 dB @ 1.25 Gb/s, BER <10 -12 w/
PRBS 2 -7 -1. See Note 1
Note 1: Total system budget is defined as P
out
– P
in
– typical connector losses.