Fisher D500243X012 - Manual (Page 4)

Instruction Manual
D500243X012
1035/El-O-Matic Actuator
August 2012
4
Table 3. Approximate Weights
ACTUATOR SIZE
kg lbs
EDA ESA EDA ESA
E25 1.2 1.7 2.7 3.7
E40 1.8 2.4 4.0 5.3
E65 2.4 3.6 5.3 7.9
E100 2.8 4.6 6.1 10.1
E200 5.8 9.1 12.8 20.1
E350 10.4 16.9 22.9 37.3
E600 19.4 27.6 42.8 60.8
E900 26.4 38.6 58.2 85.0
E1600 42.7 65.8 94.1 145
P2500/P2505 56.7 88.0 125 194
P4000/P4005 86.2 132.0 190 291
Table 4. Bolting Torques between 1035 and Yoke
ACTUATOR SIZE Bolt Diameter, Inches Torque, NSm Torque, lbfSft
E25 1/4 11 8.3
E40
E65
E100
5/16 22 16.5
E200
E350
3/8 39 29
E600 1/2 91 67
E950 5/8 163 120
E1600 3/4 258 190
P2500/P2505
P4000/P4005
3/4 203 150
Installation
When an actuator and a valve are shipped together, the actuator is normally mounted on the valve. Follow the valve
body instructions when installing the control valve in the pipeline. If the actuator is shipped separately from the valve
or if it is necessary to mount the actuator on the valve, perform the procedures in the Actuator Mounting section.
WARNING
Always wear protective gloves, clothing, and eyewear when performing any installation operations to avoid personal
injury.
To avoid personal injury or property damage caused by bursting of pressure-retaining parts, be certain the service
conditions do not exceed the limits given in table 1. Use pressure-limiting devices or pressure-relieving devices to prevent
the cylinder pressure from exceeding these limits.
If hoisting the valve and actuator assembly or the actuator by itself, take precautions to prevent people from being injured
in case the hoist or sling slips unexpectedly. Refer to table 3 for actuator weights. Carefully position the sling to prevent
damage to tubing or any accessories.
Check with your process or safety engineer for any additional measures that must be taken to protect against process
media.
If installing into an existing application, also refer to the WARNING at the beginning of the Maintenance section in this
instruction manual.