Frymaster Heated Landing Zone HLZ - Manual (Page 8)

HEATED LANDING ZONE
CHAPTER 5: COMPUTER OPERATION AND PROGRAMMING
6
5.2 Operation
1.
Press the power button, turning the HLZ on (the display will light and cycle through an initialization
sequence). The display will read -LO- until the air heater and heater plate are within 15°F of setpoint. It will
take approximately 10 minutes for the HLZ to achieve operating temperature.
NOTE: A small LED will light in the display when the heater plate or air heater is energized.
Press to turn on the computer.
The display will read LO until both heaters are within 15° F of setpoint.
When the HLZ is ready for operation, the display reads R E d y (ready). Place product in the HLZ in
accordance with the restaurant’s established procedures.
NOTE: To check the actual temperature of a heater, press the corresponding Temperature button once.
To check the setpoint temperature of a heater, press the button twice (an indicator will light when the
setpoint is displayed).
R E y
Heater Plate
Air Heater Activation
d
¡
220F
Temperature
Setpoint Indicator