Fisher-Price EF20B - Manual (Page 13)

2
Type
1
Features Forward-Facing Installation
24
LATCH Installation
Figure1illustratesatypicalforward-facing
LATCHinstallation.
IMPORTANT!.Verify that your vehicle is
equipped with lower anchors. If lower anchors
are not installed, you must use vehicle belt
installation methods (see pages 26–29).
1...Lift.up.cover.from.seat.and.remove.the.lower.
hook.strap.and.lower.hooks.out.of.the.rear-facing.
belt.path.OR.from.the.storage.slots.
(Fig. 2). Pull.
hooks.through.forward-facing.path. (Fig. 3).
2.. .Press.and.hold.the.lower.adjuster.release.
button,.then.pull.to.lengthen.lower.hook.strap.
to.full.length..
3.. .Verify.that.the.lower.hook.strap.is.not.twisted,.
then.attach.the.left.lower.hook.to.left.lower.
anchor.in.desired.seating.position.
(Fig. 4)...
Pull.on.lower.hook.to.confirm.attachment.to.
lower.anchor.
4.. .Verify.that.the.lower.hook.strap.is.not.twisted,.
then.attach.the.right.lower.hook.to.right.lower.
anchor.in.desired.seating.position...Pull.on.
lower.hook.to.confirm.attachment.to.lower.
anchor.
1
2
4
3
25
Forward-Facing Installation
5
5.. .Kneel.on.the.restraint.to.push.it.into.the.
vehicle.seat.while.pulling.the.lower.hook.strap.
tight.
(Fig. 5).
6..Install.tether.as.instructed.on.pages.32–33..
7.. .Verify.that.all.connections.are.secure.and.the.
restraint.is.stable...A.secure.restraint.should.
allow.no.more.than.1.inch.of.side-to-side.or.
forward.movement.at.the.belt.path.
LATCH Removal
1.. .Press.button.on.lower.adjuster.to.loosen.lower.
hook.strap. (Fig. 6).
2.. .Press.on.tab.to.release.hook.from.lower.anchor.
3.. Disconnect.the.tether...
 IMPORTANT!When not in use, always
store the lower hooks in storage slots under
cover (see page 16, Fig 2).
6
4a
Always use in upright position in
forward-facing mode. See page 11.
warning