Fisher PLC-XU100 - Manual (Page 25)

25
Basic Operation
Remote Control
D.ZOOM
buttons
NO SHOW
button
AUTO PC
button
✔
Note:
• See the previous page for the other buttons.
POINT ed
buttons
black out
➜ the captured image ➜ normal ➜
• • • • •
Press the NO SHOW button on the remote control to black
out the image. To restore to normal, press the NO SHOW
button again or press any other button. When a projected
image is captured and set as “User” in the Logo selection
(p.43), the screen changes each time you press the NO
SHOW button as follows.
The message will disappear after 4 seconds.
NO SHOW button
Press the AUTO PC button on the remote control to operate
the Auto PC function.
For more detail, see 28.
AUTO PC button
Press the D.ZOOM buttons on the remote control to zoom
in and zoom out the images.
For more detail, see 34.
D.ZOOM buttons
Press the P-TIMER button on the remote control. The timer
display “00 : 00” will appear on the screen and the timer
will start to count time (00 : 00 ~ 59 : 59).
To stop the P-Timer, press the P-TIMER button. Press the
P-TIMER button again, then the P-timer display will
disappear.
P-TIMER button
LAMP CONTROL button
P-Timer display
Press the IMAGE button on the remote control to select a
desired image level of the screen.
For more detail, see p31, 38.
IMAGE button
LAMP CONTROL
button
P-TIMER button
IMAGE button
Volume +/-
buttons
(See p23)
Press the LAMP CONTROL button on the remote control to
select the lamp mode for changing the brightness of the
screen.
Auto ..........brightness according with the input signal
High ..........brighter than the Normal mode
Normal ......normal brightness
Eco ............lower brightness reduces the lamp
power consumption and extends the
lamp life.