Fluke Ti20 - Manual (Page 25)

2-1
Chapter 2
Basic Operation
Turning the Imager On and Off
Use the G key to turn the Imager on and off. To turn on the Imager, press and hold the
G
for approximately 2 seconds until the date and time appear in the upper right-hand
corner of the display. The Imager splash screen appears until the Imager can reliably
show an accurate thermal image. After approximately 5 seconds, the Imager loads the
Home display.
The Imager splash screen is shown in Figure 2-1 and displays the following information:
• Date and Time
• Fluke and MicroIR logos
• Model Number
• Serial Number
• Firmware Version
• Route Name (if uploaded to Imager)
dag102f.eps
Figure 2-1. Imager Splash Screen