Foundry Networks CK-300 - Manual (Page 15)

G e t s t a r t e d
15
Switch on
If the ignition sense wire is connected, turn on the car ignition. When
the car kit is switched on, the CarMenu application installed on your
mobile device starts up, and the indicator light of the input device turns
on.
If the ignition sense wire is not connected, press and hold the Navi
wheel.
Switch off
If the ignition sense wire is connected, turn off the car ignition. If you
turn off the ignition during a call, the car kit switches off after you end
the call or disconnect the mobile device from the car kit.
If the ignition sense wire is not connected, press and hold the Navi
wheel until the indicator light of the input device turns off. After you
turn off the car ignition, do not leave the mobile device connected to
the car kit to prevent accidental draining of the car battery.
■ Connect your mobile device to the car kit
You can connect the car kit to a compatible mobile device using
Bluetooth wireless technology.
To use the car kit with the CarMenu application, install the application
on your mobile device before you pair and connect the device to the car
kit.
Bluetooth wireless technology
Bluetooth wireless technology allows you to connect compatible
devices without cables. A Bluetooth connection does not require that
the two devices be in line of sight, but the devices should be within
10 meters (30 feet) of each other. The connection is subject to
interference from obstructions, such as walls, or other electronic
devices.
The car kit is compliant with Bluetooth Specification 1.2 supporting the
following profiles: Handsfree Profile 1.5, Advanced Audio Distribution