Name of parts, En-3 – Friedrich MR18C3F User Manual

Page 4

Advertising
background image

En-3

Fig. 1 Indoor Unit

1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button

When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.

The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.

When the forced cooling operation starts
by any chance, press the START/STOP but-

ton to stop the operation.

3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)

If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting

(See Page 14 Auto Restart).

7 SUPER QUIET Indicator Lamp (green)
8 SWING Indicator Lamp (orange)

9 Intake Grille (Fig. 4)
0 Front Panel
A Air Filter
B Air Flow Direction Louver
C Right-Left Louver

(behind Air Flow Direction Louver)

D Drain Hose
E Air Cleaning Filter

Fig. 5 Outdoor Unit

F Pipe Unit
G Drain port (bottom)
H Intake Port
I Outlet Port

Fig. 6 Remote Control Unit

J SLEEP button
K MASTER CONTROL button
L SET TEMP. button (

/ )

M Signal Transmitter
N TIMER MODE button
O TIMER SET (

/

) button

P FAN CONTROL button
Q START/STOP button
R SET button
S SWING button
T RESET button
U TEST RUN button

● This button is used when installing the

conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.

● If this button is pressed during normal op-

eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.

● To stop the test operation mode, press the

START/STOP button to stop the air condi-
tioner.

V CLOCK ADJUST button
W Remote Control Unit Display (Fig. 7)
X Transmit Indicator
Y Clock Display
Z Operating Mode Display
[ Timer Mode Display
\ Fan Speed Display
] Temperature SET Display
` SLEEP Display
a SWING Display

NAME OF PARTS

● Refer to the folded out page on the cover.

06B030_9315255044-01_En

2006.2.6, 1:47 PM

3

Advertising
This manual is related to the following products: