Furuno GP-1650F - Manual (Page 37)

4-3
PLOT
▲
' TIME
™ DISTANCE
▼
Figure 4-5 Plot window
4. Press ▲ or ▼ to select TIME or DIS-
TANCE. Distance is useful for conserv-
ing track memory, since no track is
recorded when the boat is stationary.
5. Press the soft key ENTER or the [ENTER]
key.
Track plotting interval
1. Press the [MENU] key followed by the soft
keys CHART SETUP OPTIONS and
TRACK CONTROL.
2. Press ▲ or ▼ to select TIME INTERVAL
or DIST INTERVAL.
3. Press the soft key EDIT to display the in-
terval window.
TIME INTERVAL
0 1 m 00 s
(When selecting TIME INTERVAL.)
DIST INTERVAL
0 0.10 nm
(When selecting DIST INTERVAL.)
Figure 4-6 Interval window
4. Use the cursor pad to place the cursor on
the digit desired. The [CLEAR] key func-
tions to clear an entire line of data.
5. Press appropriate alphanumeric key to
enter value.
6. Repeat steps 4 and 5 to complete.
7. Press the soft key ENTER or the [ENTER]
key.
4.5 Changing Track Memory
Capacity
The equipment stores a total of 5000 points
of track and marks. This total may be freely
apportioned as desired. The default setting
is 2000 points of track and 3000 marks. You
can change the memory capacity for track
and marks. Note that when this is done all
tracks and marks in the memory are
erased.
1. Press the [MENU] key followed by the soft
keys CHART SETUP OPTIONS and
TRACK CONTROL.
2. Press ▼ to select TRACK MEMORY.
3. Press the soft key EDIT to display the
TRACK MEMORY window.
TRACK MEMORY
1 000/5000 POINTS
Figure 4-7 TRACK MEMORY window
The TRACK MEMORY window may be
erased by pressing the soft key CANCEL
to escape.
4. Enter number of track memory points
desired with the alphanumeric keys.
Note that all digits may be cleared by
pressing the soft key CLEAR or the
[CLEAR] key in entering track memory
points.
5. Press the soft key ENTER or the [ENTER]
key. The following window appears to ask
you if you are sure to change the track
memory capacity.
RESETTING ERASES
TRACK, MARK/LINE
YES ... "ENTER" key
NO ... "CLEAR" key
ALREADY SAVED. OK?
Figure 4-8 ERASE messege
6. Press the [ENTER] key to change appor-
tion, or press the [CLEAR] key to escape.