Furuno FE-700 - Manual (Page 29)

23
Note: If CHANGEOVER is set for MANUAL, select SINGLE.
49.6
0
20
40
60
80 m
49.6
BELOW SURFACE
0
49.6
m
BELOW SURFACE
20
40
60
80
SINGLE: Single frequency DUAL: Dual frequency
f) DISP ORDER sets where to locate the fore and aft displays (right or left side) in the dual
frequency display.
g) OUTPUT sets what data to output to external equipment (in IEC/NMEA data format) in case
of dual frequencies. Select FORE to output FORE data, or AFT to output AFT data.
h) MEMORIZE sets the source (transducer) for data recording (depth, etc.) in case of dual
frequencies. Select DUAL, FORE or AFT as appropriate. DUAL records both FORE and AFT
data for 12 hours. FORE or AFT records respective data for 24 hours.
4. Reset the power.
Note: The default settings in the TRANSDUCER SETTING window are N/A. At the first
power-up after installation, the window appears to set transducer(s).