5 double-feed detection conditions – FUJITSU Image Scanner fi-4120C User Manual

Page 107

Advertising
background image

6.5 Double-feed Detection Conditions

fi-4120C Image Scanner Operator’s Guide

91

ADF AND P

A

PER SPECIFICA

T

ION

6

6.5

Double-feed Detection Conditions

There are three double-feed detection modes: document thickness, document length, and both doc-
ument thickness and length. The following conditions must be satisfied in each of these detection
modes.

■ Detection by Document Thickness

Sheets of the same thickness shall be set in the ADF at a time.

• Document thickness: 0.065 to 0.15mm

• Printed area: 12% or less

• No black printed areas are allowed at the center area (26 x 10mm) at the leading edge of the

document.

• Punched holes are not allowed within 35mm of the vertical center line of the document.

• The deviation in the amount of the light transmitted through background areas must not be

less than 10%.

■ Detection by Document Length

Sheets of the same length shall be set in the ADF at a time.

• Document length deviation: 1% or less

• Punched holes are not allowed within 35mm of the vertical center line of the document.

■ Detection by Document Thickness and Length

Sheets of the same thickness and length shall be set in the ADF at a time.

• Document thickness: 0.065 to 0.15mm

• Document length deviation: 1% or less

• Printed area: 12% or less

• No black printed areas are allowed at the center area (26 x 10mm) at the leading edge of the

document.

• Punched holes are not allowed within 35mm of the vertical center line of the document.

• The deviation in the amount of the light transmitted through background areas must not be

less than 10%.

Advertising