FUJITSU 461V FA - Manual (Page 25)

Color monitor 461V FA
A26361-K708-Z100-2-5E19 English - 17
Selecting input signal
The monitor can be operated with analogue or digital signals. With this function you can (depending
on the graphics card you use) switch over between the analogue and the digital mode.
Calling the INPUT SELECTION setting window
Switch on the analogue mode ( ANALOG ). The monitor processes the signals of
the analogue port (VGA/D-SUB).
Switch on the digital mode ( DIGITAL ). The monitor processes the signals of the
digital port (DVI-D).
Locking the OSD menu (OSD Lock)
The OSD menu can be locked to prevent accidental or unauthorised changes to the monitor
settings.
Ê Press the OK button and hold it for approx. 10 seconds.
Please proceed in the same manner to release the locked OSD menu again.
Notes on ergonomic colour adjustment
If you select colours for the display in your application programs, take note of the information below.
The primary colours blue and red on a dark background do not produce the minimum required
contrast of 3:1 and are therefore not suitable for continuous text and data entry.
When using several colours for characters and background and giving the primary colours full
modulation, you can obtain very suitable colour combinations (see the following table):
Background Characters
black white purple blue cyan green yellow red
black + + - + + + -
white + + + - - - +
purple + + - - - - -
blue - + - + - + -
cyan + - - + - - -
green + - - + - - -
yellow + - + + - - +
red - + - - - - +
+ Colour combination very suitable
- Colour combination not suitable because colour locations are too close together, thin
characters are not identifiable or rigorous focusing is demanded of the human eye.