Furuno Ls4100 - Manual (Page 41)

35
Water temp/speed sensor
Connect the optional water temp/speed
sensor to the XDR connector with the
optional converter connector (Type
02S4147) as shown below.
Tape connectors with
vulcaninzing tape
and then vinyl tape
to waterproof them.
Bind tape ends with
cable ties to prevent
tape from unraveling.
Connect to XDR port
at rear of display unit
MJ-A10SPF
MJ-A10SRMD MJ-A6SRMD
From
transducer From
sensor
Connection of converter
connector 02S4147
4.8 IEC 61162-1 Data
Sentences
The tables below show the data
sentences which can be input to and
output from the LS-4100. The
transmission speed for both input and
output is 4800 bps. Data is output at
two-second intervals.
Input data sentences
Sentence Meaning
BWC Bearing and distance to
waypoint
GGA Global positioning system
(GPS) fix data
GLL Geographic position -
latitude/longitude
HDG Heading, deviation and variation
HDT Heading, true
MDA Atmospheric pressure
MTW Water temperature
Input data sentences (con’t)
Sentence Meaning
MWV Wind speed and
angle
RMA Recommended
minimum specific
LORAN-C data
RMB Recommended
minimum navigation
information
RMC Recommended
minimum specific
GPS/TRANSIT data
VHW Water speed and
heading
VTG Course over ground
and ground speed
XTE Cross track error
Output data sentences
Sentence Meaning
DBT (Ver. 1.5)
Depth below
transducer
DPT (Ver. 2.0, Ver.
3.0)
Depth
MTW* Water temperature
RMB* (Ver. 2.0) Recommended
minimum
navigation
information
VHW* Water speed and
heading
TLL* Target position,
output by [MARK]
key.
*= Available with connection of optional
sensors/navaid