Ferris Industries HydroCut Series 5900111 - Manual (Page 26)

24 www.ferrisindustries.com
Maintenance
CHECKING / ADDING FUEL
To add fuel:
• Remove the fuel cap.
• Fill the tank.
Do not overfill. Leave approximately 1” of room in
the tank for fuel expansion. Refer to your engine
manual for specific fuel recommendations.
• Install and hand tighten the fuel cap.
FUEL FILTER
The fuel filter is located in the fuel line between the
fuel shut off valve and the fuel pump. If filter is dirty
or clogged, replace as follows:
• Shut off the fuel valve.
• Place a container below the filter to catch spilled
fuel.
• Using pliers, open and slide hose clamps from fuel
filter.
• Remove hoses from filter.
• Install new filter in proper flow direction in fuel line.
• Secure with hose clamps.
OIL & FILTER CHANGE
1. Warm engine by running for a few minutes. (Refer
to the engine operator’s manual for oil & filter
replacement instructions.)
2. Park machine and place the rear tires in a 2 x 4
block of wood or park machine on a slight downhill
grade. (See Figure 6)
3. Place a small pan under the oil drain hose (B,
Figure 7) to catch the oil.
4. Using a 10mm combination wrench or a large
slotted screwdriver, turn the oil drain valve (A)
counterclockwise to open the valve and drain the
engine oil.
5. After draining, turn the oil drain valve (A)
clockwise to close the valve and wipe up any
spilled oil.
6. Place a small pan or cup under the engine oil
filter.
7. Remove the engine oil filter and replace with a
new one.
8. Remove the pan or cup and wipe up any spilled
oil.
CHECK / CHANGE AIR FILTER
Refer to engine owners manual.
REPLACE SPARK PLUG
Refer to engine owners manual.
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the
area. Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread
hose clamps further than necessary. Ensure
clamps grip hoses firmly over filter after
installation.
Do not use gasoline containing
METHANOL, gasohol containing more
than 10% ethanol, gasoline additives,
premium gasoline, or white gas because
engine/fuel system damage could result.
Regular Maintenance
Figure 6. Raise Rear of Machine
A. 2 x 4 Block
A
Figure 7. Oil Drain Hose Location
A. Oil Drain Valve
B. Oil Drain Hose
A
B