Festool OF 2200 EB - Manual (Page 13)

13
Always advance the router in
the same direction as the cutting direc-
tion of the cutter (counter-routing)!
Procedure:
Preset the required routing depth.
Switch on the machine.
Unscrew the rotary knob [13.1].
Push the machine down as far as pos-
sible.
Clamp the machine in this position by tight-
ening the rotary knob [13.1].
Perform the routing task.
Unscrew the rotary knob [13.1].
Move the machine slowly upwards to the
stop.
Switch off the machine.
Machine guidance methods
a) Routing with side stop
The side stop (partly as an accessory) is po-
sitioned parallel to the workpiece edge.
15.7
15.6
15.5
15.4 15.1 15.2 15.3
Secure both guide rods [15.4] with the two
rotary knobs [15.2] on the side stop.
Insert the guide rods into the grooves on
the router base to the required distance
and secure them by turning the rotary knob
[15.1].
Fine adjustment
Unscrew the rotary knob [15.7] to make
fi ne adjustments with the adjusting wheel
[15.5]. The dial ring [15.6] has a 0.1 mm
scale for this purpose. If the adjusting
wheel is held secure, the dial ring can be
turned separately and set to "Zero". The
–
–
–
–
–
–
–
–
–
–
–
–
millimetre scale [15.3] on the main casing
is useful for making larger adjustments.
Tighten the rotary knob [15.7] again after
completing any fi ne adjustments.
16.4
16.2
16.3
16.1
Adjust both guidance jaws [16.3] so that
they are approx. 5 mm from the router bit.
To do this, undo screws [16.2] and tighten
again after completing the adjustments.
Only when routing along an edge: slide
the extractor hood [16.1] until it latches
into position on the side stop and connect
an extraction hose 27 mm or 36 mm in
diameter to the extractor connector [16.4].
Alternatively, leave the machine to extract
the dust via the extractor connector.
b) Copy routing
When routing with templates, fi t an integrated
copying ring to the router (accessory).
Note:
Copying rings can be used in combination
with the standard base runner. A special
base runner is available as an accessory to
improve the contact surface.
An excessively large routing
tool may damage the copying ring and
cause accidents. Make sure that the routing
tool used fi ts through the opening on the
copying ring.
Procedure:
17.1
17.2
17.3
17.4
Lay the machine on its side on a stable
base.
–
–
–
f
–